Snow White resin (SW)

The Snow White resin is the ideal resin for those who seek to give great visual realism to your prints, by default you will print your pieces in an ideal white for architectural models or even teeth (product indicated for dental prosthetics) but you will also have the opportunity to mix the resin with one of the four pigments available (blue, black, red and yellow) to obtain which painters the tone and color desired. If you want to give color to your prints you can buy the pack of pigments that comes with 4 units (red colors) , yellow, blue and black) of 20ml each. With the Snow White resin all your printed objects will have a very high resolution and will look like fresh out of an injection mold. The maximum shrinkage that your pieces are going to present is only 0.5%. The resin, once completely cured, has a shore hardness of 83 D. The Snow White resin is available in white color. 1 liter volume capacity. The approximate dimensions of the product are 26x10x10 cm. The useful life of the resin is about 1 year. Store the product in an environment between 10ºC and 25ºC. An environment of excessive heat will prematurely polymerize the resin. Resin that has not cured in an impression can be reused for later printing.

56.71 VAT not included

In stock

The resin is composed of three elements, the photo initiator, the monomer and the inhibitor photo. The initiating photo once exposed to ultraviolet light causes the monomer to harden. The mission of the inhibitor photo is to prevent ultraviolet light from curing too much in depth. The exposure time of the ultraviolet light, the% of the initiator photo and the inhibitor photo% make it possible to work with the layer height desired. With a DLP projector that emits between 2500 and 3000 lumens, the Fun To Do resin takes between 2 and 4 seconds to cure for a layer height of 75 microns (0.075mm). Times are the ones used for the SLA SolidRay 3d printer. There are multiple factors that directly affect the cure times needed for each resin, such as: layer height, resin color, projector lumens, brightness and contrast of the projector , distance between projector and resin,... The times indicated are for guidance. And once the piece is printed do not forget:

* Insert and remove the piece in a bath of isopropyl alcohol between 2 and 4 minutes to remove remains of resin , use a soft brush if necessary.

* Wipe off any remaining isopropyl alcohol with a spray of compressed air or a hair dryer (with no hot air).

* Leave the sun between 20 and 40 minutes or under ultraviolet light between 1 and 8 minutes - depending on the piece (uv light lamps for drying nail polish also work).

Additional information

Weight 1000 g
Carrito
There are no products in the cart!
Seguir viendo
0